How To Fix KE767 - Table "&1" is empty

SAP Error Message - Details

• Message type: E = Error

• Message class: KE -

• Message number: 767

• Message text: Table "&1" is empty

What causes this issue?

The system should read data from table "&V1&". However, this table does
not contain any data.

System Response

This error situation causes the program to terminate.

How to fix this error?

The program is instructed to read data from table "&V1&". However, this
table is empty. Check whether you have run the program in the right
context.
In some cases, user entries can determine which table the data should
be read from. In such cases, check the parameter values that you
entered for the program when you started it.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message KE767 - Table "&1" is empty ?

  The SAP error message KE767, which states "Table '&1' is empty," typically occurs in the context of controlling (CO) when you are trying to execute a report or transaction that requires data from a specific table, but that table does not contain any entries. The placeholder "&1" will be replaced with the name of the specific table that is empty.
  Causes:
  
  No Data Entry: The most common cause is that the table in question has not been populated with any data. This could be due to a lack of transactions or postings that would normally populate the table.
  Incorrect Selection Criteria: The selection criteria used in the report or transaction may be too restrictive, leading to no data being retrieved.
  Data Deletion: Data may have been deleted from the table due to data archiving or other data management processes.
  Configuration Issues: There may be configuration issues in the controlling module that prevent data from being recorded in the table.
  Timing Issues: If the report is run immediately after a posting, the data may not yet be available due to processing delays.
  
  Solutions:
  
  Check Data Entry: Verify that relevant transactions have been posted to the system. If not, ensure that the necessary entries are made.
  Review Selection Criteria: Check the selection criteria used in the report or transaction. Adjust them to ensure that they are not overly restrictive.
  Data Consistency Check: Run consistency checks or reports to ensure that the data in the controlling area is consistent and that there are no issues with data integrity.
  Review Configuration: Check the configuration settings in the controlling module to ensure that everything is set up correctly for data to be recorded.
  Check for Data Deletion: Investigate if any data deletion or archiving processes have affected the table. If necessary, restore data from backups if it was deleted unintentionally.
  Wait for Processing: If the report is run immediately after a posting, wait for a short period and then try running the report again.
  
  Related Information:
  
  Transaction Codes: Depending on the context, you may want to look at transaction codes like KOB1 (Order Line Items), KSB1 (Cost Centers), or KSV1 (Plan/Actual Comparison) to see if data exists in related tables.
  Table Names: The specific table name indicated in the error message will provide context. Common tables in CO include COSS (Cost Totals for Internal Orders), COSP (Cost Line Items), and others.
  SAP Notes: Check SAP Notes for any known issues or patches related to the error message KE767. SAP frequently updates its knowledge base with solutions for common issues.
  
  If the problem persists after trying the above solutions, it may be beneficial to consult with your SAP support team or a technical consultant who can provide deeper insights into the specific configuration and data setup in your SAP environment.