How To Fix KA446 - The increment may only lie in the area from 1 - &

KA446 - Overview

• Message type: E = Error

• Message class: KA - CO Overhead Costs: Overhead, Accrual Calculation

• Message number: 446

• Message text: The increment may only lie in the area from 1 - &

What causes this issue?

You chose an increment of &V1& that is not possible for the specified
area of &V2& to &V3&, since it would lead to non-allowed overlapping.
Therefore, the highest increment may be &V1&, but must be at least 1.

System Response

It is not possible for you to use the chosen increment for renumbering.

How to fix this error?

Choose a smaller increment.

Error message extract from SAP system. Copyright SAP SE.

KA446 - Details

• The SAP error message KA446 indicates that there is an issue with the increment value specified in a configuration or transaction related to cost accounting or internal orders. The message states that the increment must fall within a specific range, typically from 1 to a defined upper limit (denoted by "&").
  
  Cause:
  
  Invalid Increment Value: The increment value you are trying to enter is either less than 1 or exceeds the maximum allowed value.
  Configuration Error: There may be a configuration issue in the system settings that defines the valid range for increments.
  Data Entry Error: A typographical error or misunderstanding of the required input format could lead to this error.
  
  
  Solution:
  
  Check the Increment Value: Ensure that the increment value you are entering is within the valid range (1 to the maximum allowed value). Adjust the value accordingly.
  Review Configuration Settings: If you have access, check the configuration settings in the relevant module (e.g., controlling or