How To Fix GPDPEG101 - Group-to-group: receiving group &3 is not included in the current run

SAP Error Message - Details

• Message type: E = Error

• Message class: GPDPEG - A&D GPD message classed used by Pegging only

• Message number: 101

• Message text: Group-to-group: receiving group &3 is not included in the current run

What causes this issue?

A group-to-group transfer exists between the selected groups and &V3&,
however &V3& is not included in the pegging run.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Include &V3& on the selection screen of the pegging report.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPDPEG101 - Group-to-group: receiving group &3 is not included in the current run ?

  The SAP error message GPDPEG101 indicates that there is an issue with group-to-group processing in the SAP system, specifically that the receiving group (denoted as &3 in the error message) is not included in the current run. This typically occurs in the context of production planning or project management where groups are defined for processing tasks.
  Cause:
  
  Group Configuration: The receiving group may not be configured correctly in the system or may not be part of the current processing run.
  Selection Criteria: The selection criteria for the current run may not include the specified receiving group.
  Data Integrity Issues: There may be inconsistencies or missing data in the master data related to the groups involved.
  Authorization Issues: The user may not have the necessary authorizations to access or process the specified group.
  
  Solution:
  
  Check Group Configuration: Verify that the receiving group is correctly defined in the system. Ensure that it is active and included in the relevant configuration settings.
  Review Selection Criteria: Check the selection criteria for the current run to ensure that the receiving group is included. Adjust the criteria if necessary.
  Data Validation: Validate the master data for both the sending and receiving groups to ensure there are no inconsistencies or missing entries.
  Authorization Check: Ensure that the user has the necessary authorizations to access and process the specified group. If not, contact your system administrator to grant the required permissions.
  Run a New Process: If the issue persists, consider running a new process or job that includes the receiving group, ensuring that all necessary parameters are set correctly.
  
  Related Information:
  
  Transaction Codes: Depending on the context, you may need to use specific transaction codes to check group configurations or run processes (e.g., MD01, MD02 for MRP runs).
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message. SAP frequently updates its knowledge base with solutions for common problems.
  Documentation: Refer to SAP documentation for detailed information on group-to-group processing and configuration settings.
  
  If the problem continues after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant who can provide deeper insights into the specific configuration and setup of your SAP environment.