How To Fix GPD2039 - No MRP Group for plant &1, material &2. Replenishment &3 &4 not pegged.

GPD2039 - Overview

• Message type: E = Error

• Message class: GPD2 - GPD for DIMP4.71 uses message class GPD & GPD2

• Message number: 039

• Message text: No MRP Group for plant &1, material &2. Replenishment &3 &4 not pegged.

What causes this issue?

There is no MRP Group defined for the plant &1 and material
&2 combination. For this reason, the replenishment object
&3 &4 has not been pegged.

System Response

In order to consider a replenishment object for pegging, you must
define MRP Group for the material and plant combination of that
replenishment.
It could be that the replenishment object is in a plant where it should
not be. Please also check the plant of this replenishment object.

How to fix this error?

First, you must check to see that the plant &1 is relevant for
GPD processes.
If the plant is not relevant for GPD, then pegging will not peg any
replenishments from this plant, to any requirements in this plant.
If you still wish to peg this replenishment, then you must <ZH>either
move the replenishment to another plant that is relevant for pegging,
or define an MRP Group for the plant / material combination in
question. </>
You can define the MRP Group for the material using the Material
Master.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GPD2039 - No MRP Group for plant &1, material &2. Replenishment &3 &4 not pegged. ?

  The SAP error message GPD2039 indicates that there is no MRP (Material Requirements Planning) group assigned for a specific plant and material combination. This error typically arises during the planning process when the system attempts to perform MRP calculations but cannot find the necessary configuration for the specified material in the given plant.
  
  Cause:
  
  Missing MRP Group: The most common cause is that the material does not have an MRP group assigned in the material master data.
  Incorrect Plant Configuration: The plant may not be properly configured to use the specified MRP group.
  Material Master Data Issues: The material master record may be incomplete or incorrectly set up, particularly in the MRP views.
  Replenishment Strategy: The replenishment strategy for the material may not be set up correctly, leading to issues in pegging.
  
  
  Solution:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03).
  Check the MRP views (MRP 1, MRP 2, etc.) to ensure that an