How To Fix G4806 - Manipulation rule & is not configured in JV.

G4806 - Overview

• Message type: E = Error

• Message class: G4 - EC-CS Consolidation

• Message number: 806

• Message text: Manipulation rule & is not configured in JV.

What causes this issue?

The Manipulation rule &V1& was assigned in a cycle segment but was
not created in Joint venture configuration. This situation can only
occur, if manipulation rule &V1& was deleted from the JV configuration
tables after it has been used in a cycle.

System Response

Posting not possible.

How to fix this error?

Please maintain &V1& in JV configuration or use a valid manipulation
rule in your cycle segment.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message G4806 - Manipulation rule & is not configured in JV. ?

  The SAP error message G4806, which states "Manipulation rule & is not configured in JV," typically occurs in the context of Joint Venture (JV) accounting within SAP. This error indicates that a specific manipulation rule that is required for processing a transaction is not set up in the system.
  
  Cause:
  
  Missing Configuration: The manipulation rule referenced in the error message has not been defined in the Joint Venture (JV) configuration settings.
  Incorrect Setup: The manipulation rule may have been incorrectly set up or deleted, leading to the system being unable to find it when processing a transaction.
  Data Entry Error: There may be a mistake in the data entry where the manipulation rule is referenced incorrectly.
  
  
  Solution:
  
  
  Check Configuration:
  
  Navigate to the configuration settings for Joint Venture Accounting in SAP.
  Ensure that the manipulation rule mentioned in the error message is defined and properly configured.
  You can access the configuration through the following path: 
  SPRO ? Financial Accounting ?