How To Fix G0541 - Cons unit set &1 will not be overwritten in target dimension &2

G0541 - Overview

• Message type: E = Error

• Message class: G0 - Messages for SAP Consolidation

• Message number: 541

• Message text: Cons unit set &1 will not be overwritten in target dimension &2

What causes this issue?

You want to copy cons unit set &V1&. However, a cons unit set with the
same name already existings in target dimension &V2&.
Since cons unit sets can contain other cons unit sets and themselves be
contained in other sets. you may need to delete dependent sets after
overwriting a cons unit set. To prevent inadvertent deletion of sets,
the function "Existing settings: Overwrite" is not supported for cons
unit sets.

System Response

The cons unit set &V1& will not be overwritten in dimension &V2&.

How to fix this error?

Should any cons unit sets be overwritten in the target dimension,
delete the sets concerned and proceed as follows:
Switch to dimension &V2& by changing the global parameters.
Delete cons unit set &V1& in Consolidation Customizing.
Rerun the copy program using the same parameters.

Error message extract from SAP system. Copyright SAP SE.

G0541 - Details

• The SAP error message G0541 indicates that there is an issue with the consistency of the unit of measure (UoM) settings in the context of a data transfer or a planning scenario. Specifically, it means that the consistency unit set (cons unit set) associated with a certain target dimension cannot be overwritten due to existing constraints or settings.
  
  Cause:
  
  Inconsistent Unit Settings: The target dimension already has a defined unit set that conflicts with the one you are trying to apply.
  Data Integrity Constraints: The system is designed to prevent overwriting existing configurations that could lead to data integrity issues.
  Locked or Inactive Settings: The target dimension may be locked or inactive, preventing any changes to its unit settings.
  
  
  Solution:
  
  Check Existing Unit Sets: Review the existing unit sets associated with the target dimension. Ensure that the unit set you are trying to apply is compatible.
  Modify or Delete Conflicting Settings: If necessary, modify or delete the