How To Fix FTR_TEX1031 - Exposure category &1 with aggregation used in more than one sequence

FTR_TEX1031 - Overview

• Message type: E = Error

• Message class: FTR_TEX1 - Messages for raw exposures

• Message number: 031

• Message text: Exposure category &1 with aggregation used in more than one sequence

What causes this issue?

Exposure category is assigned to more than one sequence type.
As defined in the exposure category settings, this exposure category is
aggregated in E-Hedge Accounting. For this, the exposure category must
be assigned to one sequence type only so that the system can uniquely
identify the predecessor of the exposure category in the sequence.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

To make the aggregation possible, assign the exposure category to one
sequence type only.
Otherwise, deselect the respective aggregation checkbox under
<DS:SIMG.TEXV_EXP_CAT>Define Exposure Categories</>.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FTR_TEX1031 - Exposure category &1 with aggregation used in more than one sequence ?

  The SAP error message FTR_TEX1031 indicates that there is an issue with the exposure category in the context of financial transactions, particularly in the area of Treasury and Risk Management. This error occurs when an exposure category is being used in more than one sequence with aggregation, which is not allowed.
  
  Cause:
  The error is typically caused by the following scenarios:
  
  Duplicate Exposure Categories: The same exposure category is defined in multiple sequences within the same report or configuration.
  Incorrect Configuration: The configuration of exposure categories and their sequences may not be set up correctly, leading to conflicts.
  Aggregation Settings: The aggregation settings for the exposure categories may overlap, causing the system to flag this as an error.
  
  
  Solution:
  To resolve the FTR_TEX1031 error, you can take the following steps:
  
  
  Check Configuration:
  
  Go to the configuration settings for exposure categories in the SAP system.
  Ensure that each exposure category is assigned to only one sequence. If the same category is