How To Fix FRMLMSC139 - Primary output &1: Density in spec. does not equal calculated density

FRMLMSC139 - Overview

• Message type: E = Error

• Message class: FRMLMSC - RMS-FRM: Miscellaneous Messages for Formula

• Message number: 139

• Message text: Primary output &1: Density in spec. does not equal calculated density

What causes this issue?

The system calculated the density for primary output &V1&. This does
not match the density that was specified in the specification of the
primary output.

System Response

The formula is inconsistent and the consistency indicator has not been
set.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FRMLMSC139 - Primary output &1: Density in spec. does not equal calculated density ?

  The SAP error message FRMLMSC139 indicates that there is a discrepancy between the density specified in the material specification and the density that has been calculated based on the formula or the components involved. This error typically arises in the context of formula management in SAP, particularly when dealing with materials that have specific density requirements.
  
  Cause:
  
  Mismatch in Density Values: The density value defined in the material master or formula does not match the density calculated from the components of the formula.
  Incorrect Component Data: The components used in the formula may have incorrect density values defined in their material master records.
  Formula 
  Configuration Issues: There may be issues with how the formula is configured, leading to incorrect calculations.
  Changes in Material Properties: If there have been recent changes to the material properties or the components, the calculated density may no longer align with the specified density.
  
  
  Solution:
  
  Verify Density Values: Check the density value specified