How To Fix FRMLDLG202 - System cannot display the component total in unit &1

SAP Error Message - Details

• Message type: E = Error

• Message class: FRMLDLG - RMS-FRM: Dialog Messages for Formula

• Message number: 202

• Message text: System cannot display the component total in unit &1

What causes this issue?

The value calculated is below or above the range that can be displayed.

System Response

The system does not display the component total.

How to fix this error?

Choose a different unit of measure for calculating the component total.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FRMLDLG202 - System cannot display the component total in unit &1 ?

  The SAP error message FRMLDLG202, which states "System cannot display the component total in unit &1," typically occurs in the context of material management or production planning when the system is unable to calculate or display the total quantity of a component in a specific unit of measure.
  Causes:
  
  Unit of Measure Issues: The unit of measure for the component may not be defined correctly in the system, or there may be inconsistencies in the unit of measure settings.
  Missing Data: Required data for the component, such as quantity or conversion factors, may be missing or incorrectly configured.
  Configuration Errors: There may be issues with the configuration of the material master or BOM (Bill of Materials) that prevent the system from calculating totals.
  Authorization Issues: The user may not have the necessary authorizations to view or access the component data.
  System Bugs or Limitations: There may be bugs in the SAP version being used or limitations in the system that prevent the display of the component total.
  
  Solutions:
  
  
  Check Unit of Measure Configuration:
  
  Verify that the unit of measure for the component is correctly defined in the material master.
  Ensure that the conversion factors between different units of measure are set up correctly.
  
  
  
  Review BOM and Material Master:
  
  Check the BOM for the component to ensure that all necessary data is present and correctly configured.
  Review the material master data for the component to ensure that it is complete and accurate.
  
  
  
  Data Consistency Check:
  
  Run consistency checks in the system to identify any discrepancies in the data related to the component.
  
  
  
  User Authorizations:
  
  Ensure that the user has the necessary authorizations to view the component data. This may involve checking roles and permissions in the SAP system.
  
  
  
  Consult SAP Notes:
  
  Check the SAP Support Portal for any relevant SAP Notes or patches that address this specific error message. There may be known issues or fixes available.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CS03 (Display BOM), MM03 (Display Material), or CST04 (Display Unit of Measure) to investigate the issue further.
  Documentation: Refer to SAP documentation for detailed information on unit of measure settings and BOM configuration.
  Community Forums: SAP Community forums can be a valuable resource for finding similar issues faced by other users and potential solutions.
  
  By following these steps, you should be able to identify the cause of the FRMLDLG202 error and implement a suitable solution.