How To Fix FRMLCALC027 - Volume for item &1 was taken from aeration volume

SAP Error Message - Details

• Message type: E = Error

• Message class: FRMLCALC - Formula Calculations

• Message number: 027

• Message text: Volume for item &1 was taken from aeration volume

What causes this issue?

The system attempted to determine the volume from the ratio of density
to aeration density for the item &V1&. This was not possible.

System Response

The system takes the aeration volume as the volume value.

How to fix this error?

Check the densities given for the item and add any missing information
if necessary.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FRMLCALC027 - Volume for item &1 was taken from aeration volume ?

  The SAP error message FRMLCALC027 indicates that the volume for a specific item (denoted by &1) was derived from the aeration volume rather than the expected volume. This error typically occurs in the context of process engineering or production planning, particularly when dealing with formulas and calculations related to materials or production processes.
  Cause:
  
  Incorrect Configuration: The item may not have been properly configured in the system, leading to the system defaulting to the aeration volume.
  Missing Data: Required data for the item may be missing or incorrectly entered, causing the system to pull from an alternative source (aeration volume).
  Formula Issues: The formula used for calculating the volume may not be set up correctly, leading to incorrect references.
  Material Master Data: The material master data for the item may not be complete or accurate, affecting how volumes are calculated.
  
  Solution:
  
  Check Configuration: Review the configuration settings for the item in question. Ensure that all relevant parameters are correctly set up.
  Verify Data: Check the material master data for the item to ensure that all necessary information is present and accurate.
  Review Formulas: Examine the formulas used in the calculation to ensure they are correctly referencing the intended volumes and not defaulting to aeration volume.
  Adjust Settings: If the aeration volume is not appropriate for the calculation, adjust the settings or data to ensure the correct volume is used.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling this error message.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM02 (Change Material) or C223 (Change Formula) to review and modify the relevant data.
  SAP Notes: Check for any SAP Notes related to this error message for additional insights or patches that may address the issue.
  User Forums: Consider visiting SAP community forums or user groups for shared experiences and solutions from other users who may have encountered the same error.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant who can provide more in-depth assistance.