How To Fix FDT_SERVICE359 - Quantities with dimensions ('&1' and '&2') cannot be multiplied

SAP Error Message - Details

• Message type: E = Error

• Message class: FDT_SERVICE - Formula & Derivation Tool: Services

• Message number: 359

• Message text: Quantities with dimensions ('&1' and '&2') cannot be multiplied

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FDT_SERVICE359 - Quantities with dimensions ('&1' and '&2') cannot be multiplied ?

  The SAP error message FDT_SERVICE359 indicates that there is an issue with multiplying quantities that have different dimensions or units of measure. This typically occurs in scenarios where you are trying to perform calculations involving quantities that are not compatible due to differing units or dimensions.
  Cause:
  The error arises when you attempt to multiply two quantities that have incompatible dimensions. For example, if you try to multiply a length (e.g., meters) by a weight (e.g., kilograms), the system will not allow this operation because the dimensions do not match.
  Solution:
  To resolve this error, you should:
  
  
  Check the Units of Measure: Verify the units of measure for the quantities involved in the multiplication. Ensure that they are compatible for the operation you are trying to perform.
  
  
  Convert Units: If the units are not compatible, consider converting one or both quantities to a common unit of measure before performing the multiplication.
  
  
  Review Calculation Logic: If you are using a custom calculation or formula, review the logic to ensure that you are not inadvertently trying to multiply incompatible dimensions.
  
  
  Consult Documentation: If you are unsure about the dimensions or units of measure, refer to the relevant SAP documentation or consult with a functional consultant who specializes in the area you are working on.
  
  
  Debugging: If you are working with custom code or enhancements, you may need to debug the code to identify where the incompatible dimensions are being introduced.
  
  
  Related Information:
  
  SAP Notes: Check for any SAP Notes related to this error message for additional guidance or patches that may address the issue.
  Unit of Measure Configuration: Review the configuration of units of measure in your SAP system to ensure they are set up correctly.
  Documentation: Refer to SAP Help documentation for more information on handling quantities and units of measure in calculations.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.