How To Fix ESH_CHECK_CONN089 - Current system is a copy of another system. No check for connector &1

SAP Error Message - Details

• Message type: E = Error

• Message class: ESH_CHECK_CONN - Check connector consistency

• Message number: 089

• Message text: Current system is a copy of another system. No check for connector &1

What causes this issue?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

The selected connector is not valid, so it cannot be read. The check on
it fails.

How to fix this error?

Use the task list SAP_ESH_ADJUST_AFTER_COPY in client 000 to adjust the
Enterprise Search specific data in all clients. The execution is only
possible if there were no changes in Enterprise Search specific clients
before. If this process does not finish successful, reset the Enterprise
Search specific data in this client with the task list SAP_ESH_RESET.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ESH_CHECK_CONN089 - Current system is a copy of another system. No check for connector &1 ?

  The SAP error message ESH_CHECK_CONN089 indicates that the current system is a copy of another system, and as a result, there is no check for the specified connector. This typically occurs in scenarios where a system has been copied from a production or another environment, and the system configuration related to connectors has not been properly adjusted or updated.
  Cause:
  
  System Copy: The error arises when the system is a copy of another system (e.g., a sandbox or test system created from a production system).
  Connector Configuration: The connectors that are supposed to be checked may not be configured or activated in the copied system.
  Missing or Incomplete Setup: The necessary setup for the connectors may not have been completed after the system copy.
  
  Solution:
  
  Check Connector Configuration: Verify the configuration of the connectors in the copied system. Ensure that they are set up correctly and are active.
  Reconfigure Connectors: If the connectors are not configured, you may need to reconfigure them according to the requirements of your system.
  System Settings: Review the system settings and ensure that all necessary parameters are correctly set up for the connectors to function.
  Transport Requests: If there are transport requests related to the connectors, ensure they have been imported into the copied system.
  Consult Documentation: Refer to SAP documentation or notes related to the specific connectors you are using for any additional configuration steps that may be required after a system copy.
  SAP Support: If the issue persists, consider reaching out to SAP support for assistance, especially if there are specific configurations or customizations involved.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide guidance on connector configuration.
  System Copy Documentation: Review SAP documentation on system copies to ensure that all necessary steps were followed during the copy process.
  Connector Types: Understand the types of connectors you are using (e.g., SAP HANA, BW, etc.) and their specific requirements.
  
  By following these steps, you should be able to resolve the error and ensure that the connectors are functioning correctly in your SAP environment.