How To Fix ESH_CHECK_CONN088 - The active default request of the connector &1 is an internal request

SAP Error Message - Details

• Message type: E = Error

• Message class: ESH_CHECK_CONN - Check connector consistency

• Message number: 088

• Message text: The active default request of the connector &1 is an internal request

What causes this issue?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

The model of the connector to be checked has an active default request
which is defined as internal. Therefore this connector will not be
available for searching in Fiori-UI.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ESH_CHECK_CONN088 - The active default request of the connector &1 is an internal request ?

  The SAP error message ESH_CHECK_CONN088 indicates that the active default request of the connector is an internal request. This typically occurs in the context of the SAP Enterprise Search (SAP ESH) when there is an issue with the configuration of the connector or the request being processed.
  Cause:
  
  Internal Request: The error suggests that the system is trying to process an internal request instead of a valid external request. This can happen if the connector is not properly configured or if the request is not set up correctly.
  Connector Configuration: The connector may not be pointing to the correct data source or may not be activated properly.
  System State: The system might be in a state where it cannot process external requests due to maintenance or other issues.
  
  Solution:
  
  
  Check Connector Configuration:
  
  Go to the SAP ESH configuration settings and verify that the connector is correctly configured.
  Ensure that the connector is pointing to the correct data source and that it is activated.
  
  
  
  Review Default Request:
  
  Check the default request settings for the connector. Make sure that it is not set to an internal request.
  If necessary, create a new default request that points to the correct external data source.
  
  
  
  System Logs:
  
  Review the system logs for any additional error messages or warnings that might provide more context about the issue.
  Use transaction codes like SLG1 (Application Log) to check for logs related to the connector.
  
  
  
  Re-activate the Connector:
  
  Sometimes, simply reactivating the connector can resolve the issue. Deactivate and then reactivate the connector in the ESH settings.
  
  
  
  Check for Updates:
  
  Ensure that your SAP system is up to date with the latest patches and updates, as this can sometimes resolve underlying issues.
  
  
  
  Consult Documentation:
  
  Refer to the official SAP documentation for Enterprise Search and connectors for any specific configuration steps or troubleshooting tips.
  
  
  
  Contact SAP Support:
  
  If the issue persists after trying the above steps, consider reaching out to SAP Support for further assistance.
  
  
  
  Related Information:
  
  SAP ESH Documentation: Review the official SAP documentation for Enterprise Search to understand the configuration and management of connectors.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they found effective.
  Transaction Codes: Familiarize yourself with relevant transaction codes such as SE80 (Object Navigator) and SE11 (Data Dictionary) for deeper investigation into the connector and data sources.
  
  By following these steps, you should be able to diagnose and resolve the issue related to the ESH_CHECK_CONN088 error message.