How To Fix EPM023 - Only the unit &2 is allowed for the report &1

SAP Error Message - Details

• Message type: E = Error

• Message class: EPM - Messages for Plant Manager Role

• Message number: 023

• Message text: Only the unit &2 is allowed for the report &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message EPM023 - Only the unit &2 is allowed for the report &1 ?

  The SAP error message EPM023 ("Only the unit &2 is allowed for the report &1") typically occurs in the context of SAP Business Planning and Consolidation (BPC) or SAP BusinessObjects Planning and Consolidation (BPC) when there is a mismatch between the unit of measure being used in a report and the unit that is allowed for that specific report.
  Cause:
  
  Unit Mismatch: The report you are trying to run is configured to accept only a specific unit of measure (e.g., currency, quantity), and the data you are trying to input or the unit you are using does not match this allowed unit.
  Configuration Issues: The report may have been set up incorrectly, or the underlying data model may not be aligned with the report's requirements.
  Data Entry Error: Users may have inadvertently selected or entered an incorrect unit of measure when inputting data.
  
  Solution:
  
  Check Report Configuration: Review the configuration of the report to ensure that it is set up to accept the correct unit of measure. This may involve checking the report properties or settings in the BPC administration console.
  Use the Correct Unit: Ensure that you are using the unit of measure that is specified for the report. If the report only allows a specific unit (e.g., "USD" for currency), make sure to select or enter that unit.
  Data Validation: Validate the data being input to ensure that it conforms to the expected units. This may involve checking the data entry forms or input templates.
  Consult Documentation: Refer to the SAP documentation or help resources for specific guidance on the report in question and the units it supports.
  Contact Support: If the issue persists after checking the above, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Training: Ensure that users are trained on the correct procedures for entering data and running reports to minimize the occurrence of such errors.
  System Logs: Review system logs for any additional error messages or warnings that may provide more context about the issue.
  
  By following these steps, you should be able to resolve the EPM023 error and successfully run your report.