How To Fix EL177 - No interval check carried out for device &1, register &2

SAP Error Message - Details

• Message type: E = Error

• Message class: EL - IS-U meter reading data processing

• Message number: 177

• Message text: No interval check carried out for device &1, register &2

What causes this issue?

Several meter reading results were found within the interval. This
could result in an error that cannot be corrected via standard
transactions.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Note:
This error may have also been caused because the register is installed
in several installations, already underwent the interval check during
order creation for the first installation, and was already interpolated
(due to settings in table V_TE611).

System Response

How to fix this error?

Check whether the device is installed in several installations. If this
is not the case, either reduce the interval or delete meter reading
results manually and create orders again.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EL177 - No interval check carried out for device &1, register &2 ?

  The SAP error message EL177 "No interval check carried out for device &1, register &2" typically occurs in the context of energy management or utility billing within the SAP IS-U (Industry Solution for Utilities) module. This error indicates that the system did not perform an interval check for a specific device and register combination, which can lead to issues in billing or data accuracy.
  Cause:
  
  Missing Configuration: The device or register may not be properly configured in the system, leading to the absence of the necessary interval check settings.
  Data Inconsistency: There may be inconsistencies in the data related to the device or register, such as missing or incorrect entries in the master data.
  Interval Data Not Available: The required interval data for the device or register may not be available or may not have been collected.
  Incorrect Settings: The settings for the interval check may not be correctly defined in the system, leading to the error.
  
  Solution:
  
  
  Check Device and Register Configuration:
  
  Verify that the device (e.g., meter) and register are correctly configured in the system.
  Ensure that the necessary parameters for interval checks are set up correctly.
  
  
  
  Review Master Data:
  
  Check the master data for the device and register to ensure that all required fields are filled out correctly.
  Look for any inconsistencies or missing data that could prevent the interval check from being performed.
  
  
  
  Verify Interval Data:
  
  Ensure that the interval data for the device and register is available and has been correctly collected.
  If necessary, reprocess the data collection to ensure that all relevant data is present.
  
  
  
  Check Configuration Settings:
  
  Review the configuration settings for interval checks in the SAP system.
  Make sure that the settings align with the business requirements and that the interval check is enabled for the relevant devices and registers.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the EL177 error message for additional troubleshooting steps or specific configuration requirements.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights based on the specific version of SAP you are using and any known issues.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like EL31 (for device management) or EL22 (for register management) to check configurations.
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide patches or updates.
  User Forums: Consider checking SAP community forums or user groups for discussions related to this error, as other users may have encountered and resolved similar issues.
  
  By following these steps, you should be able to identify the cause of the EL177 error and implement a solution to resolve it.