How To Fix EL129 - Device &1 register &2: MR result already plausible. Release not advisable

SAP Error Message - Details

• Message type: E = Error

• Message class: EL - IS-U meter reading data processing

• Message number: 129

• Message text: Device &1 register &2: MR result already plausible. Release not advisable

What causes this issue?

The meter reading result is already plausible. A release is no longer
necessary.
You may have tried to release the meter reading on the basis of an
error message issued through the validation. If the error class 'W'
(Warning) has been defined for the validation, the meter reading result
is given the status 'plausible'. The remaining validations are run
after the notification has been confirmed. In this case, an explicit
release is no longer necessary. However, it is still possible to branch
to the correction screen.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EL129 - Device &1 register &2: MR result already plausible. Release not advisable ?

  The SAP error message EL129 indicates that there is an issue with the plausibility check of a measurement result (MR) for a device. Specifically, the message states that the measurement result has already been marked as plausible, and therefore, releasing it again is not advisable. This typically occurs in the context of energy management or utility billing within SAP.
  Cause:
  
  Plausibility Check: The measurement result has already been processed and marked as plausible. This means that the system has already validated the data, and any further attempts to release or modify it are restricted to maintain data integrity.
  Duplicate Processing: There may have been an attempt to process the same measurement result multiple times, leading to this error.
  Configuration Issues: There could be issues with the configuration of the measurement points or devices that are causing the system to misinterpret the status of the measurement results.
  
  Solution:
  
  Review Measurement Results: Check the measurement results for the specified device and register. Ensure that the results are correct and that no duplicate entries exist.
  Check Status: Verify the status of the measurement result in the system. If it is already marked as plausible, you may not need to take any further action unless there is a specific reason to change it.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on handling measurement results and plausibility checks.
  Adjust Configuration: If the issue is related to configuration, review the settings for the device and measurement points to ensure they are set up correctly.
  Contact Support: If the issue persists and you cannot determine the cause, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  Related Information:
  
  Transaction Codes: You may need to use specific transaction codes related to measurement results, such as EL31 (Display Measurement Document) or EL30 (Display Measurement Point).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  User Roles: Ensure that you have the appropriate permissions to view and modify measurement results in the system.
  
  By following these steps, you should be able to address the EL129 error message effectively.