How To Fix EHSB_RC059 - Division by zero: Conversion factor for unit &1 in table T006

EHSB_RC059 - Overview

• Message type: E = Error

• Message class: EHSB_RC - Compliance Check

• Message number: 059

• Message text: Division by zero: Conversion factor for unit &1 in table T006

What causes this issue?

The table T006 defines all units of measurement that are available in
the system. The conversion factors between the units are defined as
follows: (numerator/denominator) * exponent.
The value in the <ls>Denominator</> column for the unit ' &v1&' equals
zero and this leads to a division by zero.

System Response

The system terminates the compliance check because the units used in the
composition cannot be converted.

How to fix this error?

Correct the appropriate entry in the table T006 (column MSEHI = ' &v1&
'). The value in the <ls>Denominator</> column cannot equal zero.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHSB_RC059 - Division by zero: Conversion factor for unit &1 in table T006 ?

  The SAP error message EHSB_RC059, which indicates "Division by zero: Conversion factor for unit &1 in table T006," typically occurs when there is an attempt to perform a calculation involving a unit of measure that does not have a valid conversion factor defined in the T006 table. This can happen in various scenarios, such as when processing materials, handling inventory, or performing calculations in Environmental Health and Safety (EHS) modules.
  
  Cause:
  
  Missing Conversion Factor: The unit of measure (UoM) specified in the operation does not have a corresponding conversion factor in the T006 table.
  Incorrect Unit of Measure: The unit of measure being used may not be defined correctly or may not exist in the system.
  Data Inconsistency: There may be inconsistencies in the data, such as missing entries or incorrect configurations in the unit of measure settings.
  
  
  Solution:
  
  
  Check T006 Table: 
  
  Go to transaction code SE16 or SE16N and enter the table name T006.
  Search for