How To Fix EHPRC_RCS189 - Assignment updated for property &1/characteristic &2 (test run)

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_RCS - REACH Compliance Messages

• Message number: 189

• Message text: Assignment updated for property &1/characteristic &2 (test run)

What causes this issue?

The test run detected that the property &V1&/characteristic &V2&
assignment already exists in table TCG66, but a phrase set and a
user-defined text are not set for this assignment.

System Response

How to fix this error?

Run the report again. Choose to save the changes to adopt the phrase
set/user-defined text settings for the property &V1&/characteristic &V2&
assignment.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_RCS189 - Assignment updated for property &1/characteristic &2 (test run) ?

  The SAP error message EHPRC_RCS189 typically indicates that an assignment has been updated for a specific property and characteristic in a test run mode. This message is often related to the handling of data in the Environment, Health, and Safety (EHS) module, particularly in the context of Risk Assessment or Chemical Management.
  Cause:
  
  Test Run Mode: The message indicates that the operation is being executed in test run mode. This means that the changes are not being committed to the database but are being simulated to check for potential issues.
  Data Integrity: The system may be checking for data integrity or consistency before allowing the actual update to occur.
  Configuration Issues: There may be configuration settings that are not properly set up, leading to the message being triggered.
  
  Solution:
  
  Check Test Run Settings: If you intend to perform the actual update, ensure that you are not in test run mode. You may need to change the settings to execute the operation in production mode.
  Review Data: Verify the data for the property and characteristic mentioned in the message. Ensure that they are correctly defined and that there are no inconsistencies.
  Consult Documentation: Refer to the SAP documentation for the EHPRC module to understand the specific requirements and configurations needed for the operation you are trying to perform.
  Error Handling: If you are running a batch job or a program, check the logs for any additional error messages that may provide more context on the issue.
  Contact Support: If the issue persists, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes in the EHS module that may help in troubleshooting, such as EHS0, EHS1, etc.
  SAP Notes: Check for any SAP Notes related to the EHPRC module that may address known issues or provide patches.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to address the EHPRC_RCS189 error message effectively.