How To Fix EHPRC_CPM_IMDS093 - Weight less than 0.001 mg not allowed; correct component &1

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CPM_IMDS - Messages for Checks

• Message number: 093

• Message text: Weight less than 0.001 mg not allowed; correct component &1

What causes this issue?

Component &v1& weights less than 0.001 mg.
IMDS requires a minimum weight of 0.001 mg for products, parts, basic
and surface material, and bulk material.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

INCLUDE EHPRC_IMDS_MESSAGE_RESPONSE OBJECT DOKU ID TX

How to fix this error?

Correct the weight of the component or change the components's relevance
for IMDS.

Procedure for System Administrators

INCLUDE EHPRC_CPM_CHECK OBJECT DOKU ID TX
IMDS 2093.
INCLUDE EHPRC_IMDS_MESSAGE_WORDING OBJECT DOKU ID TX

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CPM_IMDS093 - Weight less than 0.001 mg not allowed; correct component &1 ?

  The SAP error message EHPRC_CPM_IMDS093 indicates that there is an issue with the weight of a component in the IMDS (International Material Data System) data. Specifically, it states that the weight of a component is less than 0.001 mg, which is not allowed in the system.
  Cause:
  
  Incorrect Weight Entry: The weight of a component has been entered incorrectly, possibly due to a data entry error or misunderstanding of the required units.
  Component Definition: The component may not have been defined correctly in the system, leading to an incorrect weight calculation.
  Data Import Issues: If data was imported from another system or file, there may have been a conversion error or misalignment in the data.
  
  Solution:
  
  Check Component Weight: Review the weight of the component in question. Ensure that it is entered in the correct unit and that it meets the minimum weight requirement.
  Correct Data Entry: If the weight is indeed less than 0.001 mg, you will need to either adjust the weight to a valid value or remove the component if it is not significant.
  Review Component Definition: Ensure that the component is defined correctly in the system, including its weight and other relevant attributes.
  Consult Documentation: Refer to SAP documentation or guidelines for IMDS to understand the weight requirements and how to properly enter component data.
  Contact Support: If you are unable to resolve the issue, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  Related Information:
  
  IMDS Compliance: Ensure that your data complies with IMDS standards, as there are specific requirements for material data submissions.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  Training: If this error occurs frequently, consider providing training for users on how to properly enter and manage component data in SAP.
  
  By following these steps, you should be able to resolve the error and ensure that your component data is compliant with the required standards.