How To Fix EHPRC_CPM_CHECK093 - Specification has a weight which is smaller than 0.000001 grams

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CPM_CHECK - Messages for Checks

• Message number: 093

• Message text: Specification has a weight which is smaller than 0.000001 grams

What causes this issue?

IMDS accepts the basic products, materials, surfaces, and bulks only if
the weight is greater than 0.000001 grams.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

To modify the product structure during the export to IMDS, use the BOS
explosion user exit <ZH>BOSEXPL</>.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CPM_CHECK093 - Specification has a weight which is smaller than 0.000001 grams ?

  The SAP error message EHPRC_CPM_CHECK093 indicates that there is an issue with the weight specification of a material or product in the system. Specifically, it means that the weight assigned to a specification is smaller than 0.000001 grams, which is not acceptable in the context of the system's validation rules.
  Cause:
  
  Incorrect Weight Entry: The weight of the material or product may have been entered incorrectly, possibly due to a data entry error.
  Unit of Measure Issues: There may be a mismatch in the unit of measure being used, leading to an incorrect weight being calculated or displayed.
  Data Migration Issues: If data was migrated from another system, it’s possible that the weight values were not converted correctly.
  Specification Configuration: The configuration of the material specification may not align with the expected standards or requirements.
  
  Solution:
  
  Review Weight Entry: Check the weight value entered for the specification. Ensure that it is a valid and reasonable value that meets the minimum requirement.
  Adjust Units of Measure: Verify that the unit of measure for the weight is correctly set. If necessary, convert the weight to a more appropriate unit that fits within the acceptable range.
  Data Correction: If the weight was migrated from another system, review the migration process and correct any discrepancies in the weight values.
  Consult Documentation: Refer to SAP documentation or guidelines for the specific module you are working with to understand the acceptable weight ranges and formats.
  Contact Support: If the issue persists after checking the above points, consider reaching out to SAP support or your internal IT team for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional context.
  Material Master Data: Review the material master data for the affected item to ensure all specifications are correctly defined.
  Validation Rules: Understand the validation rules set up in your SAP system regarding weight specifications to prevent similar issues in the future.
  Training: Ensure that users entering data into the system are trained on the correct procedures for entering weight and other critical specifications.
  
  By following these steps, you should be able to resolve the error and ensure that the weight specifications in your SAP system are accurate and compliant with the required standards.