How To Fix EHPRC_CPM_CHECK028 - Enter part &1 as piece in composition &2

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CPM_CHECK - Messages for Checks

• Message number: 028

• Message text: Enter part &1 as piece in composition &2

What causes this issue?

In composition &v2&, you have not entered the part &v1& with the unit
<LS>piece.</>

System Response

How to fix this error?

Change the unit of measure for part &v1&.

Procedure for System Administrators

Be aware that the unit <LS>piece</> is the language-dependent unit for
the internal unit <AB>ST</> that you find in the table T006.
INCLUDE EHPRC_CPM_CHECK OBJECT DOKU ID TX
28.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CPM_CHECK028 - Enter part &1 as piece in composition &2 ?

  The SAP error message EHPRC_CPM_CHECK028 typically occurs in the context of the SAP Environment, Health, and Safety (EHS) module, particularly when dealing with product compliance management. This error indicates that there is an issue with the way a part is being entered in a composition.
  Cause:
  The error message "Enter part &1 as piece in composition &2" suggests that the system expects a specific part (denoted as &1) to be entered in a certain way (as a piece) within a composition (denoted as &2). This could be due to:
  
  Incorrect Unit of Measure: The part may be defined with a unit of measure that is not compatible with the expected input for the composition.
  Configuration Issues: There may be configuration settings in the material master or the EHS module that are not set up correctly.
  Data Entry Error: The user may have entered the part incorrectly or in an unexpected format.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Unit of Measure:
  
  Verify the unit of measure for the part in question. Ensure that it is set to "piece" or the appropriate unit that the system expects.
  You can do this by navigating to the material master record for the part and checking the unit of measure settings.
  
  
  
  Review Composition Settings:
  
  Check the composition settings for the product. Ensure that the part is correctly defined within the composition and that all required fields are filled out properly.
  
  
  
  Correct Data Entry:
  
  If the part was entered incorrectly, re-enter it in the correct format as specified by the system. Make sure to follow any guidelines or requirements for entering parts in compositions.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources related to the EHS module for specific guidelines on entering parts in compositions.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert who can provide further assistance.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  EHS Configuration: Familiarize yourself with the configuration settings in the EHS module, as they can impact how parts and compositions are managed.
  Training Resources: Consider accessing training materials or resources related to SAP EHS to better understand how to manage compositions and parts effectively.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.