How To Fix EHPRC_CPM_BOMBOS103 - Environment parameter &1 for authority group is not set

EHPRC_CPM_BOMBOS103 - Overview

• Message type: E = Error

• Message class: EHPRC_CPM_BOMBOS - Messages for BOMBOS Interface

• Message number: 103

• Message text: Environment parameter &1 for authority group is not set

What causes this issue?

You didn't specify environment parameter &V1& or after running through
all parameter values and checking the condition(s) none matches.
The system assigns the authorization group for the specification that it
creates for the bill of material transfer based on the material number.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Contact your system administrator.

Procedure for System Administrators

<DS:SIMG.EHPRC_CP_BBENV>Specify Environment Parameters</>

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CPM_BOMBOS103 - Environment parameter &1 for authority group is not set ?

  The SAP error message EHPRC_CPM_BOMBOS103 indicates that an environment parameter for an authority group is not set. This typically occurs in the context of SAP's Environment Management or Process Control modules, where specific configurations are required for the system to function correctly.
  
  Cause:
  The error is caused by the absence of a required environment parameter for a specific authority group in the system configuration. This can happen due to:
  
  Missing Configuration: The environment parameter has not been defined in the system.
  Incorrect Settings: The parameter may be incorrectly set or pointing to an invalid value.
  Transport Issues: If the configuration was transported from another system, it may not have been included or may have been incorrectly transported.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Configuration:
  
  Go to the relevant configuration transaction (e.g., SPRO) and navigate to the section where environment parameters are defined.
  Verify if the environment parameter for the specified authority group is set correctly.
  
  
  
  Set