How To Fix EG498 - Do not enter unit of measurement for MR in the case of resetting regs

SAP Error Message - Details

• Message type: E = Error

• Message class: EG - IS-U device management

• Message number: 498

• Message text: Do not enter unit of measurement for MR in the case of resetting regs

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message EG498 - Do not enter unit of measurement for MR in the case of resetting regs ?

  The SAP error message EG498, which states "Do not enter unit of measurement for MR in the case of resetting regs," typically occurs in the context of Material Requirements Planning (MRP) or when dealing with material movements in SAP. This error is related to the handling of units of measurement during certain transactions, particularly when resetting or adjusting stock levels.
  Cause:
  The error is triggered when a user attempts to enter a unit of measurement (UoM) for a material when the system does not expect it, particularly in scenarios involving resetting stock or adjusting inventory levels. This can happen due to:
  
  Incorrect Transaction Type: The transaction being performed may not require a unit of measurement to be specified.
  Configuration Issues: The settings in the material master or the configuration of the MRP may not align with the expected input for the transaction.
  User Input Error: The user may have mistakenly entered a unit of measurement when it is not needed.
  
  Solution:
  To resolve the EG498 error, consider the following steps:
  
  
  Check Transaction Type: Ensure that you are using the correct transaction for the operation you are trying to perform. If you are resetting stock levels, verify that you are following the correct procedure.
  
  
  Review Material Master Data: Check the material master data for the specific material involved. Ensure that the unit of measurement settings are correctly configured and that the material is set up for the type of transaction you are performing.
  
  
  Remove UoM Entry: If you are prompted to enter a unit of measurement, try removing it and see if the transaction can proceed without it.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for guidance on the specific transaction you are using. This can provide insights into whether a UoM is required.
  
  
  Contact SAP Support: If the issue persists and you cannot identify the cause, consider reaching out to your SAP support team or consulting with SAP experts for further assistance.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide updates and patches.
  User Manuals: Review user manuals or training materials related to MRP and inventory management in SAP.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the cause of the EG498 error and implement a solution to resolve it.