How To Fix EEDM_RTP060 - Number of influencing intervals for all output parameters must be 0

EEDM_RTP060 - Overview

• Message type: E = Error

• Message class: EEDM_RTP - Messages for EDM RTP Project

• Message number: 060

• Message text: Number of influencing intervals for all output parameters must be 0

What causes this issue?

The input parameter &V1& is defined as a profile with a meter reading
profile (for consumption determination). The output parameter &V2&
contains the value &V3& as the number of influencing intervals.

System Response

If the "Meter Reading Profile" indicator is selected in an input
parameter, the number of influencing intervals must be 0 in all output
parameters to ensure that the calculation is correct.

How to fix this error?

Correct your entry by deleting the "Meter Reading Profile" indicator in
the input parameter or setting the number of intervals to 0 in all
output parameters.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EEDM_RTP060 - Number of influencing intervals for all output parameters must be 0 ?

  The SAP error message EEDM_RTP060 indicates that there is an issue with the configuration of the influencing intervals for output parameters in the context of the SAP Demand Planning (DP) or similar modules. This error typically arises when the system expects that the number of influencing intervals for all output parameters should be zero, but it finds that there are non-zero values.
  
  Cause:
  
  Incorrect Configuration: The influencing intervals for output parameters may have been incorrectly set up in the planning book or data view.
  Data Inconsistency: There may be inconsistencies in the data that lead to the system expecting zero influencing intervals but finding otherwise.
  Modeling Errors: If you are using a planning model, there might be errors in how the model is defined, particularly regarding the output parameters and their influencing intervals.
  
  
  Solution:
  
  
  Check Configuration:
  
  Go to the planning book or data view configuration and verify the settings for the output parameters.
  Ensure that the influencing intervals