How To Fix DMEE_PAYMFORMAT310 - Node &1: "Target Offset" (&2) must be smaller than "Length" (&3)

SAP Error Message - Details

• Message type: E = Error

• Message class: DMEE_PAYMFORMAT - Messages for DMEE Payment Formats

• Message number: 310

• Message text: Node &1: "Target Offset" (&2) must be smaller than "Length" (&3)

What causes this issue?

For node &V1&, an offset of &V2& was defined in the target field.
However, the target field only has a length of &V3&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE_PAYMFORMAT310 - Node &1: "Target Offset" (&2) must be smaller than "Length" (&3) ?

  The SAP error message DMEE_PAYMFORMAT310 indicates an issue with the configuration of the DMEE (Data Medium Exchange Engine) format for payment files. Specifically, the error message states that the "Target Offset" must be smaller than the "Length" defined in the DMEE node. Here’s a breakdown of the cause, solution, and related information for this error:
  Cause:
  
  Configuration Error: The error typically arises from a misconfiguration in the DMEE tree structure. The "Target Offset" specifies the starting position in the output file where the data will be written, while the "Length" specifies how many characters will be written from that position.
  Invalid Values: If the "Target Offset" is set to a value that is equal to or greater than the "Length," it results in a logical error because you cannot start writing data at a position that is outside the defined length of the field.
  
  Solution:
  
  
  Check DMEE Configuration:
  
  Go to the DMEE transaction (usually transaction code DMEE).
  Locate the specific node that is causing the error (indicated by &1 in the error message).
  Review the "Target Offset" and "Length" values for that node.
  Ensure that the "Target Offset" is less than the "Length." For example, if the "Length" is 10, the "Target Offset" should be in the range of 0 to 9.
  
  
  
  Adjust Values:
  
  If the "Target Offset" is incorrectly set, adjust it to a valid value that is less than the "Length."
  If necessary, also review other related nodes to ensure that their configurations do not lead to similar issues.
  
  
  
  Test the Configuration:
  
  After making the necessary adjustments, test the payment file generation again to ensure that the error is resolved.
  
  
  
  Related Information:
  
  DMEE Documentation: Refer to SAP documentation for detailed information on configuring DMEE formats and understanding the parameters involved.
  SAP Notes: Check for any relevant SAP Notes that might address known issues or provide additional guidance on DMEE configurations.
  Debugging: If the issue persists, consider using debugging tools or logs to trace the payment file generation process and identify any other potential misconfigurations.
  
  By following these steps, you should be able to resolve the DMEE_PAYMFORMAT310 error and successfully generate your payment files.