How To Fix DGEXC706 - Identification of material &1 does correspond to exception &2

SAP Error Message - Details

• Message type: E = Error

• Message class: DGEXC - Messages for Exceptions to DG Regulations

• Message number: 706

• Message text: Identification of material &1 does correspond to exception &2

What causes this issue?

The exception to dangerous goods specified is valid only for specific UN
numbers. However, the material has a different type of identification
number or another identification number.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Change the identification data of the dangerous goods master, or extend
the UN numbers of exceptions to dangerous goods regulations.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DGEXC706 - Identification of material &1 does correspond to exception &2 ?

  The SAP error message DGEXC706 indicates that there is a mismatch or inconsistency related to the identification of a material in the context of exceptions. This error typically arises in scenarios involving exception handling in SAP, particularly in the context of materials management or production planning.
  Cause:
  The error message DGEXC706 is triggered when the system cannot find a valid mapping or relationship between the specified material (identified by &1) and the exception type (identified by &2). This could be due to several reasons, including:
  
  Incorrect Material Number: The material number provided may not exist in the system or may have been entered incorrectly.
  Invalid Exception Type: The exception type specified may not be valid for the material in question.
  Configuration Issues: There may be configuration settings in the system that do not allow for the specified material and exception type to be linked.
  Data Inconsistencies: There could be inconsistencies in the master data or transactional data related to the material.
  
  Solution:
  To resolve the DGEXC706 error, you can take the following steps:
  
  
  Verify Material Number: Check the material number (&1) to ensure it is correct and exists in the system. You can do this by using transaction codes like MM03 (Display Material) to look up the material.
  
  
  Check Exception Type: Ensure that the exception type (&2) is valid and applicable to the material. You may need to refer to the documentation or configuration settings to confirm this.
  
  
  Review Configuration: If you have access to the configuration settings, review the settings related to exception handling for materials. Ensure that the material and exception type are properly configured to work together.
  
  
  Data Consistency Check: Run consistency checks on the material master data and related transactional data to identify any discrepancies that may be causing the issue.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for more detailed information on the specific exception types and their applicability to materials.
  
  
  Contact Support: If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as MM03 (Display Material), MM02 (Change Material), and others that may help in diagnosing the issue.
  SAP Notes: Check SAP Notes for any known issues or patches related to the DGEXC706 error message.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the root cause of the DGEXC706 error and implement a suitable solution.