How To Fix CNVOM_UI_DEL020 - Table count not started due to no analysis found; see long text

SAP Error Message - Details

• Message type: E = Error

• Message class: CNVOM_UI_DEL - Messages for Deletion Monitor

• Message number: 020

• Message text: Table count not started due to no analysis found; see long text

What causes this issue?

Table records counting requires that an analysis must be assigned to the
embedded specification.

System Response

How to fix this error?

Go to embedded specification editor, create an analysis for the ES in
the "Technical Information" tab, then execute all the steps relevant to
the analysis.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNVOM_UI_DEL020 - Table count not started due to no analysis found; see long text ?

  The SAP error message CNVOM_UI_DEL020 indicates that a table count operation could not be initiated because no analysis data was found for the specified table. This error typically occurs in the context of data migration or conversion processes, particularly when using SAP's tools for data migration, such as the SAP S/4HANA Migration Cockpit or other conversion tools.
  Cause:
  
  Missing Analysis Data: The primary cause of this error is that the system does not have any analysis data for the table in question. This could happen if the analysis step was not executed prior to the count operation.
  Incorrect Configuration: There may be issues with the configuration of the migration or conversion project, leading to the absence of necessary analysis data.
  Data Migration Tool Issues: If there are issues with the data migration tool or if it has not been properly set up, it may not generate the required analysis data.
  
  Solution:
  
  Run the Analysis Step: Ensure that you have executed the analysis step for the relevant tables before attempting to perform the count operation. This is usually done in the migration cockpit or the relevant transaction for data migration.
  Check Configuration: Review the configuration settings for your migration project to ensure that all necessary steps have been completed and that the system is set up correctly.
  Review Logs: Check the logs for any previous errors or warnings that might indicate why the analysis data was not generated.
  Re-run the Migration Tool: If necessary, re-run the migration tool or the specific transaction that generates the analysis data to ensure it is created.
  Consult Documentation: Refer to the official SAP documentation for the specific migration tool you are using to ensure that all prerequisites and steps are followed correctly.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they found effective.
  SAP Support: If the issue persists, consider reaching out to SAP Support for assistance, especially if this is part of a critical migration project.
  
  By following these steps, you should be able to resolve the CNVOM_UI_DEL020 error and successfully proceed with your data migration or conversion tasks.