How To Fix CNV_PE394 - Parameter &1 does not belong to data model, worklist or WLRL

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_PE - General messages for posting engine

• Message number: 394

• Message text: Parameter &1 does not belong to data model, worklist or WLRL

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_PE394 - Parameter &1 does not belong to data model, worklist or WLRL ?

  The SAP error message CNV_PE394 indicates that a parameter specified in a conversion or migration process does not belong to the expected data model, worklist, or Worklist Reporting Layer (WLRL). This error typically arises during data migration activities, especially when using SAP's Conversion Tools or Data Migration tools.
  Cause:
  
  Incorrect Parameter: The parameter specified in the migration or conversion process is not defined in the data model or is not recognized by the system.
  Configuration Issues: There may be a misconfiguration in the migration settings or the data model that leads to the system not recognizing the parameter.
  Version Mismatch: The version of the migration tool or the data model may not be compatible with the current system setup.
  Missing Data Model: The data model that is supposed to contain the parameter may not be properly loaded or activated in the system.
  
  Solution:
  
  Check Parameter Validity: Verify that the parameter you are using is valid and correctly spelled. Ensure it is part of the expected data model.
  Review Data Model Configuration: Ensure that the data model is correctly configured and that all necessary components are activated.
  Update Migration Tools: If you are using an older version of the migration tool, consider updating it to the latest version to ensure compatibility with your SAP system.
  Consult Documentation: Refer to the official SAP documentation for the specific migration tool you are using to ensure that you are following the correct procedures and using the correct parameters.
  Check for Missing Components: Ensure that all necessary components of the data model are present and correctly configured in your SAP system.
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Migration Tools Documentation: Review the documentation for the specific migration tool you are using, as it may contain specific guidelines for resolving this error.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.