How To Fix CM_EHENV_SCEN013 - Cannot add a duplicate calculation to the compliance scenario

CM_EHENV_SCEN013 - Overview

• Message type: E = Error

• Message class: CM_EHENV_SCEN - Compliance Scenario Messages

• Message number: 013

• Message text: Cannot add a duplicate calculation to the compliance scenario

What causes this issue?

You want to add a calculation to the compliance scenario by creating a
new calculation setup.

System Response

The system cannot add the calculation to the scenario because an
equivalent calculation is either added already, or exists for the
current location.

How to fix this error?

Add unique calculations to the compliance scenario.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHENV_SCEN013 - Cannot add a duplicate calculation to the compliance scenario ?

  The SAP error message CM_EHENV_SCEN013 indicates that there is an attempt to add a duplicate calculation to a compliance scenario in the SAP Environment, Health, and Safety (EHS) module. This error typically arises when the system detects that the calculation you are trying to add already exists in the compliance scenario.
  
  Cause:
  
  Duplicate Entry: The most common cause is that the calculation you are trying to add has already been defined in the compliance scenario.
  Incorrect Configuration: There may be a misconfiguration in the compliance scenario setup, leading to the system not recognizing that the calculation is already present.
  Data Integrity Issues: There could be issues with data integrity or inconsistencies in the database that are causing the system to misinterpret the existing entries.
  
  
  Solution:
  
  Check Existing Calculations: Review the compliance scenario to see if the calculation you are trying to add is already listed. If it is, you do not need to add it again.
  Remove