How To Fix CF085 - Only U/M with the dimension & are allowed for parameter &

CF085 - Overview

• Message type: E = Error

• Message class: CF - PRT management messages

• Message number: 085

• Message text: Only U/M with the dimension & are allowed for parameter &

What causes this issue?

You entered a unit of measure whose dimension does not correspond that
of the parameter.

How to fix this error?

Enter a unit of measure whose dimension is the same as that of the
parameter in question.

Error message extract from SAP system. Copyright SAP SE.

CF085 - Details

• The SAP error message CF085 ("Only U/M with the dimension & are allowed for parameter &") typically occurs in the context of SAP's Advanced Planning and Optimization (APO) or similar modules where unit of measure (U/M) and dimensions are critical for planning and execution processes.
  
  Cause:
  This error usually arises when there is a mismatch between the unit of measure (U/M) being used for a particular parameter and the expected dimensions for that parameter. Each parameter in SAP can have specific units of measure associated with it, and if the U/M does not match the expected dimensions, the system will throw this error.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check the U/M Configuration:
  
  Go to the configuration settings for the relevant parameter in SAP.
  Verify that the U/M you are using is correctly defined and associated with the expected dimensions.
  
  
  
  Review the Master Data:
  
  Check the master data for the material or product involved. Ensure