How To Fix BGRFC563 - bgRFC Dest. Config. &1: Appl. check and appl. check active wrong comb.

BGRFC563 - Overview

• Message type: E = Error

• Message class: BGRFC - qRFC - New Background RFC

• Message number: 563

• Message text: bgRFC Dest. Config. &1: Appl. check and appl. check active wrong comb.

What causes this issue?

The values for the name of the application check class and its
activation were combined incorrectly in the destination configuration.
The application check can be activated only when a class is specified.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Correct the configuration of the destination settings for the bgRFC
scheduler.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message BGRFC563 - bgRFC Dest. Config. &1: Appl. check and appl. check active wrong comb. ?

  The SAP error message BGRFC563 indicates an issue with the configuration of the bgRFC (background Remote Function Call) destination. Specifically, it points to a mismatch between the application check and the application check active settings for the bgRFC destination.
  
  Cause:
  The error typically arises due to one of the following reasons:
  
  Configuration Mismatch: The bgRFC destination is configured with an application check that is not consistent with the active application check settings.
  Incorrect Settings: The settings for the bgRFC destination may have been incorrectly defined, leading to a conflict between the expected and actual configurations.
  Transport Issues: If the configuration was transported from one system to another, there may be inconsistencies in the settings.
  
  
  Solution:
  To resolve the BGRFC563 error, you can follow these steps:
  
  
  Check bgRFC Destination Configuration:
  
  Go to transaction SM59 (RFC Destinations).
  Locate the bgRFC destination that is causing the issue.
  Verify the settings for the application check and ensure they are correctly configured.
  
  
  
  Adjust Application Check Settings:
  
  Ensure that