How To Fix AJ196 - Device &1 reg. &2 period &3-&4: compressibility from user exit missing

SAP Error Message - Details

• Message type: E = Error

• Message class: AJ - Billing program

• Message number: 196

• Message text: Device &1 reg. &2 period &3-&4: compressibility from user exit missing

What causes this issue?

A volume correction factor procedure that requires calculation of
compressibility and/or supercompressibility through user exit <LS>
EXIT_SAPLEA54_001</> is active for the specified register. In this
case, however, calculation was not possible, because return table
y_table_compr_factors was returned empty.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Analyze the cause of termination in your user-defined user exit.
Inform the person responsible for programming the user exit.
The person responsible for the program should note the following:
RESET N1
In the IS-U menu, choose <LS>Billing execution</> -> <LS>Billing
analysis</>.
Choose <LS>Settings</> -> <LS>General</>, then set the <LS>Debugging on
</> indicator.
Start a billing simulation with the affected contract. Enter TGHUEXIT
in the <LS>Breakpoint at</> field.
You immediately branch to the point where your user exit is called, and
you may be able to localize the error in debugging.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AJ196 - Device &1 reg. &2 period &3-&4: compressibility from user exit missing ?

  The SAP error message AJ196 indicates that there is a problem with the compressibility factor in the context of a user exit for a specific device and registration period. This error typically arises in the context of SAP's Oil and Gas or similar industries where compressibility factors are crucial for calculations related to gas volumes.
  
  Cause:
  The error message "compressibility from user exit missing" suggests that the system is trying to calculate or process data that requires a compressibility factor, but it cannot find the necessary information in the user exit. This could be due to several reasons:
  
  Missing User Exit Implementation: The user exit that is supposed to provide the compressibility factor has not been implemented or is not functioning correctly.
  Incorrect Configuration: The configuration settings for the user exit may not be set up properly, leading to the absence of the required data.
  Data Issues: The data for the specific device and registration