How To Fix ADS2KIPUPL_AL108 - If SPC is 2/6 then URR/TCBSV/TCBO/TCC/MST should not be Initial

ADS2KIPUPL_AL108 - Overview

• Message type: E = Error

• Message class: ADS2KIPUPL_AL - SPEC2000 Initial Provisioning: Upload Appl. Layer Messages

• Message number: 108

• Message text: If SPC is 2/6 then URR/TCBSV/TCBO/TCC/MST should not be Initial

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message ADS2KIPUPL_AL108 - If SPC is 2/6 then URR/TCBSV/TCBO/TCC/MST should not be Initial ?

  The SAP error message ADS2KIPUPL_AL108 typically indicates a validation issue related to the configuration of certain parameters in the system. This error arises when specific conditions regarding the configuration of SPC (Statistical Process Control) and related parameters (URR, TCBSV, TCBO, TCC, MST) are not met.
  
  Cause:
  The error message suggests that when the SPC value is set to 2/6, certain parameters (URR, TCBSV, TCBO, TCC, MST) should not be in their initial state (i.e., they should be configured or have values assigned). The initial state usually means that these parameters have not been set up or are left at their default values, which may not be appropriate for the given SPC setting.
  
  Solution:
  To resolve this error, you should:
  
  
  Check SPC Configuration: Verify the configuration of the SPC settings in your SAP system. Ensure that the SPC value is correctly set to 2/6 as intended.
  
  
  Review Related Parameters: Check the values of the parameters URR, TCBSV,