How To Fix 9J707 - Conversion data for &2 has not been maintained for material &1

SAP Error Message - Details

• Message type: E = Error

• Message class: 9J -

• Message number: 707

• Message text: Conversion data for &2 has not been maintained for material &1

What causes this issue?

Conversion data for material &V1& has not been maintained.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Maintain the conversion data for alternative units of measure in the
material master under Additional Data/Units of Measure.
<DS:TRAN.MM02>Maintain Material</>

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 9J707 - Conversion data for &2 has not been maintained for material &1 ?

  The SAP error message 9J707 indicates that conversion data for a specific material has not been maintained. This typically occurs in scenarios where there is a need to convert units of measure or when dealing with different valuation types or currencies.
  Cause:
  The error message is triggered when:
  
  The system is trying to perform a conversion for a material (identified by &1) but cannot find the necessary conversion data (identified by &2).
  This can happen if the conversion factors for the material have not been set up in the system, or if the relevant unit of measure or conversion type is missing.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Material Master Data:
  
  Go to the Material Master (transaction code MM03).
  Check the relevant views (like Basic Data, Purchasing, Sales, etc.) to ensure that the conversion data is maintained.
  Specifically, look for the "Units of Measure" section to see if the necessary conversion factors are defined.
  
  
  
  Maintain Conversion Data:
  
  If the conversion data is missing, you can maintain it using transaction code MM02 (Change Material).
  Navigate to the "Units of Measure" view and add the required conversion factors for the material.
  
  
  
  Check Unit of Measure Settings:
  
  Ensure that the units of measure you are trying to use are defined in the system.
  You can check this in the configuration settings (transaction code OMN1 for unit of measure settings).
  
  
  
  Review Configuration:
  
  If you are using custom units of measure or conversions, ensure that they are properly configured in the system.
  Check the relevant customizing settings in SPRO under Logistics General > Material Master > Basic Settings > Units of Measure.
  
  
  
  Test the Changes:
  
  After making the necessary changes, test the transaction again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  MM03: Display Material Master
  MM02: Change Material Master
  OMN1: Maintain Units of Measure
  
  
  Documentation: Refer to SAP Help documentation for detailed information on material master data and unit of measure settings.
  User Roles: Ensure that you have the necessary authorizations to make changes to material master data.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or check SAP Notes for any known issues related to this error message.