How To Fix 8B709 - Parameter &1 and &2 screen control reference &3 are not the same

SAP Error Message - Details

• Message type: E = Error

• Message class: 8B - Localization (Brazil)

• Message number: 709

• Message text: Parameter &1 and &2 screen control reference &3 are not the same

What causes this issue?

SAP has merged the parameter groups from J_1BAE in J_1BAEH or in
J_1BAEIT. However, the parameters in <(>&<)>V3<(>&<)> in J_1BAM are not
set the same.

System Response

The system does not execute the conversion.

How to fix this error?

1. Set the parameter groups the same.
2. Afterwards perform the XPRA run again (J_1BNFE_MIGRATE_SCR_CONTROL).

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 8B709 - Parameter &1 and &2 screen control reference &3 are not the same ?

  The SAP error message 8B709 indicates a mismatch in the screen control parameters for a specific screen in the SAP system. This error typically arises when there is an inconsistency between the expected parameters for a screen and the actual parameters being passed to it.
  Cause:
  The error message 8B709 is triggered when:
  
  The parameters &1 and &2 (which represent the expected and actual screen control parameters) do not match.
  The screen control reference &3 is not consistent with the parameters being used.
  This can occur due to programming errors in custom ABAP code, issues with screen modifications, or inconsistencies in the screen flow logic.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Code: Review the ABAP code that is calling the screen. Ensure that the parameters being passed to the screen match the expected parameters defined in the screen's attributes.
  
  
  Screen Attributes: Verify the screen attributes in the Screen Painter (SE80 or SE41). Make sure that the screen control parameters are correctly defined and that there are no discrepancies.
  
  
  Debugging: Use the debugger to trace the execution flow leading to the error. Check the values of the parameters being passed to the screen and compare them with what is expected.
  
  
  Consistency Check: If the screen has been modified recently, ensure that all related objects (like function modules, includes, etc.) are consistent with the changes made.
  
  
  Transport Issues: If the issue arose after a transport, check if all related objects were transported correctly and are in sync in the target system.
  
  
  SAP Notes: Search for any relevant SAP Notes that might address this specific error or provide guidance on similar issues.
  
  
  Consult Documentation: Review the documentation for the specific transaction or module you are working with to ensure that you are following the correct procedures.
  
  
  Related Information:
  
  Transaction Codes: You may want to use transaction codes like SE80 (Object Navigator) or SE41 (Menu Painter) to investigate the screen and its parameters.
  Debugging Tools: Familiarize yourself with the SAP debugging tools to effectively trace and analyze the flow of data.
  SAP Community: Consider reaching out to the SAP Community or forums for additional insights or similar experiences from other users.
  
  By following these steps, you should be able to identify the root cause of the error and implement a solution to resolve it.