How To Fix 6B078 - RU inspection correspondence for LO & &: No LO end found

SAP Error Message - Details

• Message type: E = Error

• Message class: 6B - Real estate correspondence messages

• Message number: 078

• Message text: RU inspection correspondence for LO & &: No LO end found

What causes this issue?

You want to print letters for rental unit inspections.
However, there is no end date for rental agreement &V1& &V2&, either as
a date arranged at the beginning of the agreement or a notice date.
There are only reversed or cancelled notices that are not considered
here.

System Response

No rental unit inspection is printed for this rental agreement.

How to fix this error?

If you want to print a rental unit inspection for this rental
agreement, you must first enter a notice in the system.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 6B078 - RU inspection correspondence for LO & &: No LO end found ?

  The SAP error message 6B078 indicates that there is an issue with the inspection lot (LO) correspondence in the context of Quality Management (QM) in SAP. Specifically, the message states that there is "No LO end found," which typically means that the system is unable to find a corresponding end date or status for the inspection lot in question.
  Cause:
  
  Missing Inspection Lot End Date: The inspection lot may not have been properly closed or completed, leading to the absence of an end date.
  Incorrect Configuration: There may be configuration issues in the Quality Management module that prevent the system from recognizing the end of the inspection lot.
  Data Inconsistencies: There could be inconsistencies in the data related to the inspection lot, such as missing entries or incorrect statuses.
  User Error: The user may have attempted to perform an action that requires a completed inspection lot, but the lot is still open or incomplete.
  
  Solution:
  
  Check Inspection Lot Status: Verify the status of the inspection lot in question. Ensure that it has been completed and that all necessary steps have been performed.
  Close the Inspection Lot: If the inspection lot is still open, complete the necessary inspections and close the lot properly.
  Review Configuration: Check the configuration settings in the Quality Management module to ensure that they are set up correctly for handling inspection lots.
  Data Consistency Check: Run a consistency check on the inspection lot data to identify any discrepancies or missing information.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling inspection lots and resolving related errors.
  Contact SAP Support: If the issue persists, consider reaching out to SAP support for assistance, especially if it appears to be a system-level issue.
  
  Related Information:
  
  Transaction Codes: You may want to use transaction codes like QA32 (Display Inspection Lots) or QA11 (Record Results) to investigate the status of the inspection lot.
  Quality Management Configuration: Familiarize yourself with the configuration settings in the Quality Management module, particularly those related to inspection lot processing.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.