How To Fix 5C746 - The system did not find any parameters for the current PC plan &1

5C746 - Overview

• Message type: E = Error

• Message class: 5C - HR: Messages for Switzerland

• Message number: 746

• Message text: The system did not find any parameters for the current PC plan &1

What causes this issue?

No parameters were found for the current PC action <(>&<)>V01<(>&<)>.
There is a certain call up of PC actions during which the
PC-interpreter must be given parameters that cannot be determined from
data within the system. This is the case, for example, with simulations
or for technical reasons.
Such parameters occur in the following situations:
PC-Action 22
The parameters are pre-set in the program.
PC-Schemas
Parameters are defined for the entry simulation in the standard system.
Online evaluations
In the standard system, the parameters for the calculation <ZK>Benefits
</> are defined.
PF-recalculations
In the standard system, no additional parameters are used.
While performing the function <ZK>Default parameter</>, the system
checks whether the current PC-action occurs in at least one of these
contexts and whether the parameter is defined in Customizing. The
system summarizes them and enters them into the debugger's parameter
table.

System Response

No parameters are entered because none were found during the procedure
(see above).

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 5C746 - The system did not find any parameters for the current PC plan &1 ?

  The SAP error message 5C746 ("The system did not find any parameters for the current PC plan &1") typically occurs in the context of Production Planning (PP) or Production Control (PC) when the system is unable to find the necessary parameters for a specific planning scenario or plan.
  
  Cause:
  
  Missing Configuration: The error often arises when the configuration for the specific planning scenario (identified by &1) is incomplete or missing. This could be due to a lack of defined parameters in the planning settings.
  Incorrect Plan Name: The plan name provided may not exist or may have been incorrectly specified.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access the parameters for the specified plan.
  Data Inconsistency: There may be inconsistencies in the master data or configuration settings that prevent the system from retrieving the required parameters.
  
  
  Solution:
  
  
  Check Configuration: 
  
  Go to the configuration settings for the specific planning scenario in the SAP