How To Fix 3F273 - No rounding rules found for the wage types belonging to adjustment type &

SAP Error Message - Details

• Message type: E = Error

• Message class: 3F - Compensation Management

• Message number: 273

• Message text: No rounding rules found for the wage types belonging to adjustment type &

What causes this issue?

A wage type model can be maintained for every compensation adjustment
type. This wage type model then determines which wage types are
relevant for compensation adjustment. A rounding rule can be stored for
each wage type.
In this case, no wage type model or rounding rule was found for the
compensation adjustment wage types.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Inform your system administrator to eliminate the data inconsistency.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 3F273 - No rounding rules found for the wage types belonging to adjustment type & ?

  The SAP error message 3F273 indicates that there are no rounding rules defined for the wage types associated with a specific adjustment type in the payroll process. This error typically arises during payroll processing when the system attempts to apply rounding rules to wage types but cannot find any applicable rules.
  Cause:
  
  Missing Rounding Rules: The primary cause of this error is that the rounding rules for the specified wage types have not been defined in the system.
  Incorrect Configuration: The configuration for the adjustment type may not be set up correctly, leading to the system not being able to find the necessary rounding rules.
  Wage Type Characteristics: The wage types involved may not have been assigned the correct characteristics that would allow them to utilize rounding rules.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Define Rounding Rules:
  
  Go to the SAP transaction code SPRO (Customizing).
  Navigate to Payroll -> Payroll USA (or your relevant country) -> Wage Types -> Define Rounding Rules.
  Create or modify the rounding rules for the wage types associated with the adjustment type in question.
  
  
  
  Check Adjustment Type Configuration:
  
  Ensure that the adjustment type is correctly configured to use the appropriate wage types.
  Verify that the adjustment type is linked to the correct wage types in the payroll schema.
  
  
  
  Review Wage Type Characteristics:
  
  Check the characteristics of the wage types involved to ensure they are set up to allow rounding.
  Use transaction code OH11 to review and modify wage type characteristics if necessary.
  
  
  
  Testing:
  
  After making the necessary changes, run a test payroll to ensure that the error does not occur again.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific details on rounding rules and wage type configuration.
  
  
  
  Related Information:
  
  Wage Types: These are the basic building blocks of payroll processing in SAP. Each wage type can have specific characteristics, including whether it is subject to rounding.
  Adjustment Types: These are used in payroll to adjust amounts for various reasons, such as corrections or special calculations.
  Payroll Schema: The payroll schema defines the sequence of operations that the payroll process follows, including how wage types are processed.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP payroll expert or your organization's SAP support team for further assistance.