How To Fix CMX_POC_WI006 - Conditions de sélection limitées à &1 entrées (voir txte descriptif)

SAP Error Message - Details

• Message type: E = Error

• Message class: CMX_POC_WI - PP-PI-PMA: PI Sheet Messages, SCM Add-On

• Message number: 006

• Message text: Conditions de sélection limitées à &1 entrées (voir txte descriptif)

Quelle est la cause de ce problème?

The number of sets of work instructions to be selected was limited to
&V1& on the initial screen (see specification <LS>Max. No. Work
Instructions</>). This specification has the following effects on the
selection steps performed internally:
RESET N1
Selection of work instructions without taking the status of a set of
work instructions into account:
The maximum number used on the initial screen relates to this step for
technical reasons. Step 1 was ended after this number was reached.
Fine selection from the number of hits determined in step 1 on the basis
of the status and the timespan specified in the case of the status
<ZK>New</>:
No work instructions satisfying the status requirements were found in
among the number of hits. The worklist thus remains empty. However, due
to the restriction effective in step 1, it is possible that not all
actually existing work instructions were taken into account.

Réponse du système

Le système émet un message d'erreur et ne vous permettra pas de poursuivre cette transaction tant que l'erreur n'est pas résolue.

Comment corriger cette erreur?

RESET N1
Check and narrow down your selection criteria if required.
If necessary, also increase the number of work instructions to be
selected when you call up the worklist (under <ZK>Max. Number of Work
Instructions</>.
However, note that increasing the maximum number too greatly can result
in performance problems.

Procédure pour les administrateurs système

Extrait du message d'erreur du système SAP. Copyright SAP SE.