How To Fix CM_EHFND_COMN152 - &1 : unité "&2" non valide

CM_EHFND_COMN152 - Overview

• Message type: E = Error

• Message class: CM_EHFND_COMN - Commonly Used Messages

• Message number: 152

• Message text: &1 : unité "&2" non valide

Quelle est la cause de ce problème?

You entered a unit of measurement that is not specified for the
dimension of the value.

Réponse du système

The system determines all units that are specified for the dimension of
the value in the Customizing activity <LS>Check Units of Measurement
</>under <LS>SAP NetWeaver -> General settings</>. Only these units of
measurements are permitted.
<ZH>Note: </>For values that are assigned to an amount category, the
system first determines the dimension that is specified for the amount
category in the Customizing activity <LS>Specify Amount Categories by
Hazards</> under <LS>Environment, Health and Safety -> Compliance and
Risk Management -> Master Data Configuration -> Agents. </>Then, it
determines all units that are specified for this dimension in the
Customizing activity<LS> Check Units of Measurement </>under <LS>SAP
NetWeaver -> General settings</>.

Comment corriger cette erreur?

Enter a unit that is assigned to the following dimensions: &V3&&V4&.

Procédure pour les administrateurs système

Le système émet un message d'erreur et ne vous permettra pas de poursuivre cette transaction tant que l'erreur n'est pas résolue.

Extrait du message d'erreur du système SAP. Copyright SAP SE.