Do you have any question about this error?
Message type: E = Error
Message class: UCF3 - Messages for Rounding
Message number: 003
Message text: Ratio &1 no se puede verificar y redondear a la vez
According to the current settings, key figure "&V1&" is to be checked
as well as rounded. This is not feasible.
El sistema emite un mensaje de error y no le permitirá continuar con esta transacción hasta que se resuelva el error.
Decide whether to check or to round the key figure, and change the
settings accordingly.
Extracto de mensaje de error del sistema SAP. Copyright SAP SE.
UCF3003
- Ratio &1 no se puede verificar y redondear a la vez ?Get instant SAP help. Start your 7-day free trial now.
UCF3002
Ratio &1 tiene una diferencia de &2
¿Qué causa este problema? While checking the rounding conditions for key figure "&V1&" a difference of &V2& was found.Res...
UCF3001
Ratio &1 tiene una diferencia de &2 en paso redondeo &3
¿Qué causa este problema? While checking the rounding conditions for key figure &V1& a difference of &V2& was found in step &V3...
UCF3004
Seleccione como mínimo un ratio
¿Qué causa este problema? You did not specify a key figure to be checked nor one to be rounded.Respuesta del sistema El sistema emite un mensaje d...
UCF3005
Paso método &1: Imputación diferencias fuera de condición selección
¿Qué causa este problema? The differential assignment is not within the realm of the selection condition(s). This is not allowed because otherwise,...
Haga clic en este enlace para buscar todos los mensajes de SAP.