How To Fix XT102 - Could not execute command &1 in system &2

SAP Error Message - Details

• Message type: E = Error

• Message class: XT - Transport Management System

• Message number: 102

• Message text: Could not execute command &1 in system &2

What causes this issue?

An error occurred in the TMS communication layer.
Target system: <LS>&V2&</>
Target domain: <LS>&V3&</>
Error: <LS>RFC_SYSTEM_FAILURE</>
RFC message: <LS>&V4&</>

System Response

The function terminates.

How to fix this error?

Correct the error and execute the command again.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message XT102 - Could not execute command &1 in system &2 ?

  The SAP error message XT102, which states "Could not execute command &1 in system &2," typically indicates that there was an issue executing a specific command in the SAP system. This error can arise from various causes, and understanding the context is essential for troubleshooting. Here are some common causes, potential solutions, and related information:
  Causes:
  
  Authorization Issues: The user executing the command may not have the necessary authorizations to perform the action.
  System Configuration: The command may not be configured correctly in the system, or the system may not be set up to handle the command.
  Network Issues: There could be network connectivity problems between the client and the SAP server.
  Command Syntax: The command syntax may be incorrect or not recognized by the system.
  System State: The system may be in a state that does not allow the command to be executed (e.g., during a system upgrade or maintenance).
  Resource Limitations: The system may be experiencing resource limitations (e.g., memory, CPU) that prevent the command from executing.
  
  Solutions:
  
  Check Authorizations: Ensure that the user has the necessary authorizations to execute the command. This can be done by reviewing the user's roles and permissions in the SAP system.
  Review Command Syntax: Verify that the command is correctly formatted and recognized by the system. Consult the relevant SAP documentation for the correct syntax.
  Check System Configuration: Ensure that the system is configured to handle the command. This may involve checking system settings or consulting with a system administrator.
  Network Troubleshooting: If network issues are suspected, check the network connection between the client and the SAP server. This may involve ping tests or checking network configurations.
  System Status: Check if the system is undergoing maintenance or upgrades. If so, wait until the maintenance is complete before attempting to execute the command again.
  Monitor System Resources: Use transaction codes like ST02 (Tune Summary) or ST06 (Operating System Monitor) to check for resource bottlenecks. If resources are low, consider optimizing the system or increasing resources.
  
  Related Information:
  
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  Transaction Codes: Familiarize yourself with relevant transaction codes that can help diagnose issues, such as SM21 (System Log), ST22 (Dump Analysis), and SM37 (Job Monitoring).
  Logs and Traces: Review system logs and traces for more detailed error messages that may provide additional context for the failure.
  
  If the issue persists after trying the above solutions, it may be beneficial to consult with your SAP Basis team or reach out to SAP support for further assistance.