How To Fix WOD5001 - Conversion of material &1 into restriction unit &2 is not possible

SAP Error Message - Details

• Message type: E = Error

• Message class: WOD5 -

• Message number: 001

• Message text: Conversion of material &1 into restriction unit &2 is not possible

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message WOD5001 - Conversion of material &1 into restriction unit &2 is not possible ?

  The SAP error message WOD5001 indicates that there is an issue with converting a material into a restriction unit. This typically occurs in the context of handling materials that have specific unit of measure (UoM) conversions defined in the system. Here’s a breakdown of the cause, potential solutions, and related information for this error:
  Cause:
  
  Missing Conversion Factors: The conversion factor between the base unit of measure and the restriction unit may not be defined in the material master data.
  Incorrect Unit of Measure: The unit of measure being used may not be valid for the material in question.
  Material Master Data Issues: There may be inconsistencies or missing data in the material master record.
  Configuration Issues: The configuration settings for units of measure in the system may not be set up correctly.
  
  Solution:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03) and check the "Basic Data" and "Units of Measure" views.
  Ensure that the conversion factors for the relevant units of measure are correctly defined.
  
  
  
  Define Conversion Factors:
  
  If the conversion factor is missing, you can define it in the material master by going to the "Units of Measure" view and adding the necessary conversion.
  
  
  
  Validate Unit of Measure:
  
  Ensure that the unit of measure you are trying to convert to is valid and exists in the system. You can check this in the configuration settings (transaction code OME4).
  
  
  
  Check Configuration Settings:
  
  Review the configuration for units of measure in the system. This can be done in the IMG (Implementation Guide) under Logistics General > Material Master > Basic Settings > Units of Measure.
  
  
  
  Consult Documentation:
  
  If the issue persists, consult SAP documentation or reach out to your SAP support team for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  MM03: Display Material Master
  OME4: Define Units of Measure
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  User Exits and BAdIs: If custom logic is involved in the conversion process, review any user exits or BAdIs that may affect the conversion logic.
  
  By following these steps, you should be able to identify and resolve the issue causing the WOD5001 error in SAP.