How To Fix WL328 - End of static fork (end condition is fulfilled)

SAP Error Message - Details

• Message type: E = Error

• Message class: WL - Workflow: run-time messages

• Message number: 328

• Message text: End of static fork (end condition is fulfilled)

What causes this issue?

The static fork is completed. The end condition &V1& has been
fulfilled.

System Response

The workflow is continued after the fork.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message WL328 - End of static fork (end condition is fulfilled) ?

  The SAP error message WL328, which states "End of static fork (end condition is fulfilled)," typically occurs in the context of workflow processing in SAP. This message indicates that a workflow instance has reached a point where it can no longer continue due to the fulfillment of an end condition in a static fork.
  Cause:
  
  Static Fork in Workflow: The error is related to a static fork in the workflow definition. A static fork is a point in the workflow where the process can split into multiple branches, but only one branch is expected to continue based on certain conditions.
  End Condition Fulfillment: The message indicates that the end condition for the workflow has been met, meaning that the workflow has completed its processing and is no longer active.
  Incorrect Workflow Configuration: There may be an issue with how the workflow is configured, such as incorrect conditions or missing steps that prevent the workflow from proceeding.
  
  Solution:
  
  Review Workflow Definition: Check the workflow definition in the SAP Business Workflow (transaction code SWDD). Ensure that the conditions for the static fork are correctly defined and that the workflow is set up to handle all possible paths.
  Check Workflow Logs: Use transaction code SWI1 to analyze the workflow logs. This can provide insights into what happened before the error occurred and help identify any misconfigurations or issues.
  Adjust Conditions: If the conditions for the static fork are too restrictive or not aligned with the expected workflow logic, consider adjusting them to allow for the correct continuation of the workflow.
  Test Workflow: After making changes, test the workflow thoroughly to ensure that it behaves as expected and that the error does not recur.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on workflow configuration and troubleshooting.
  
  Related Information:
  
  Workflow Monitoring: Use transaction SWI1 (Work Item Selection) or SWI2_FREQ (Work Item Selection - Frequency) to monitor workflow instances and identify any that are stuck or have errors.
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address known issues related to this error message.
  Community Forums: Engage with SAP community forums or user groups for additional insights and shared experiences from other users who may have encountered similar issues.
  
  If the problem persists after following these steps, it may be beneficial to reach out to SAP support for further assistance.