How To Fix V0307 - Source was set to F, since only one FORM routine specified

V0307 - Overview

• Message type: E = Error

• Message class: V0 - Screen sequence control messages

• Message number: 307

• Message text: Source was set to F, since only one FORM routine specified

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message V0307 - Source was set to F, since only one FORM routine specified ?

  The SAP error message V0307 indicates that the source was set to "F" (for "Function Module") because only one FORM routine was specified in the context of a function module or a report. This typically occurs when you are trying to define a function module or a report that is expected to have multiple FORM routines, but only one has been provided.
  
  Cause:
  The error arises when:
  
  You are defining a function module or a report that is expected to have multiple FORM routines, but you have only defined one.
  The system automatically sets the source type to "F" because it assumes that the single FORM routine is sufficient for the operation, which may not align with the intended design.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Function Module/Report Definition:
  
  Review the definition of your function module or report to ensure that it is correctly set up. If you intended to have