How To Fix USMD_XI_PROXY033 - Replicate hierarchy &2 from edition &1; full replication only

SAP Error Message - Details

• Message type: E = Error

• Message class: USMD_XI_PROXY - Messages for SOA Services (from EHP5)

• Message number: 033

• Message text: Replicate hierarchy &2 from edition &1; full replication only

What causes this issue?

You want to replicate hierarchy &V2& from edition &V1& . Regardless of
the current settings in DRF Customizing, the replication of the complete
hierarchy is always performed. This is because the system cannot
determine an unambiguous delta set of data.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message USMD_XI_PROXY033 - Replicate hierarchy &2 from edition &1; full replication only ?

  The SAP error message USMD_XI_PROXY033 typically occurs in the context of SAP Master Data Governance (MDG) when there is an issue with replicating a hierarchy from a specific edition. The message indicates that the system is attempting to replicate a hierarchy but can only perform a full replication due to certain constraints.
  Cause:
  The error message can be triggered by several factors, including:
  
  
  Edition Issues: The edition from which the hierarchy is being replicated may not be in a state that allows for partial replication. This could be due to the edition being locked or not being fully activated.
  
  
  Hierarchy Structure: The hierarchy structure being replicated may not support incremental updates, necessitating a full replication instead.
  
  
  Configuration Settings: There may be configuration settings in the MDG system that dictate how hierarchies are replicated, which could lead to this error if not set correctly.
  
  
  Data Consistency: There may be inconsistencies or issues with the data in the source edition that prevent a successful replication.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Edition Status: Ensure that the edition from which you are trying to replicate the hierarchy is active and not locked. You may need to unlock or activate the edition.
  
  
  Review Hierarchy Structure: Verify the structure of the hierarchy you are trying to replicate. Ensure that it is correctly defined and does not have any inconsistencies.
  
  
  Configuration Review: Check the configuration settings related to hierarchy replication in your MDG system. Ensure that they are set up to allow for the type of replication you are attempting.
  
  
  Perform Full Replication: If the system indicates that only full replication is possible, proceed with a full replication of the hierarchy. This may involve reinitializing the replication process.
  
  
  Check Logs and Traces: Review any logs or traces related to the replication process for additional details on what might be causing the issue.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to the specific version of MDG you are using for any known issues or additional troubleshooting steps.
  
  
  Contact SAP Support: If the issue persists after trying the above steps, consider reaching out to SAP support for further assistance.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional context.
  MDG Documentation: Review the Master Data Governance documentation for best practices on hierarchy replication.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.