How To Fix UPS1030 - Status &1 is the same as status &2

UPS1030 - Overview

• Message type: E = Error

• Message class: UPS1 - SEM-BPS Status and Tracking System Messages

• Message number: 030

• Message text: Status &1 is the same as status &2

What causes this issue?

You assigned a planning sequence to a status switch in the Status and
Tracking System. However, initial and target status are identical. This
is not allowed.

System Response

The settings for the planning session cannot be saved in the existing
form.

How to fix this error?

Make sure that the initial and target status differ from each other.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UPS1030 - Status &1 is the same as status &2 ?

  The SAP error message UPS1030, which states "Status &1 is the same as status &2," typically occurs in the context of the SAP system when there is an attempt to change the status of an object (such as a document, order, or other business entity) to a status that is already assigned to it. This can happen in various modules, including logistics, finance, or project management.
  
  Cause:
  The primary cause of this error is that the system is trying to set a status that is already active for the object in question. For example, if an order is already in a "Completed" status, and there is an attempt to set it again to "Completed," the system will trigger this error message.
  
  Solution:
  To resolve the UPS1030 error, you can take the following steps:
  
  
  Check Current Status: Verify the current status of the object you are trying to change. You can do this by navigating to