How To Fix UPP_PP_K017 - Too many lead columns in planning layout, see long text

SAP Error Message - Details

• Message type: E = Error

• Message class: UPP_PP_K - Messages for Planning Processor Core

• Message number: 017

• Message text: Too many lead columns in planning layout, see long text

What causes this issue?

The current planning layout contains &V1& lead columns. In manual
planning, the entry screen can then possibly not be formed when the
layout contains a two-figure number of lead columns and in addition
lots of transaction data was selected.
The admissible upper limit for the complexity of lead columns is
calculated as follows:
The entry screen can only be formed when the product from the number of
characteristic values per lead column (including the values for totals
or hierarchy nodes) is smaller than the figure 1E+31 -1.

System Response

Depending on which settings are valid for the selection conditions and
the header characteristics of the layout, the system reacts in one of
the following ways:
If only one single characteristic value combination exists for the
characteristics in the header area, then the layout cannot be opened.
If several characteristic value combinations exist, then scrolling to
such combinations, which do not meet the condition named above, is not
possible.

How to fix this error?

Reduce the number of lead columns in the planning layout to a figure
that is appropriate for manual entry. If you want to update other
characteristics, use the characteristic deviation.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.