How To Fix UPE1026 - Parameter group &1 (&2) was designated for deletion

UPE1026 - Overview

• Message type: E = Error

• Message class: UPE1 - Messages: Link to External Applications

• Message number: 026

• Message text: Parameter group &1 (&2) was designated for deletion

What causes this issue?

You have deleted parameter group &V1& (&V2&).

System Response

The system removes the parameter group from the list of available
parameter groups and designates it for final deletion from the data
basis. The final deletion takes place when ending the planning session,
or when saving the planning objects.

How to fix this error?

If you want to reverse the deletion, then exit the planning session
without saving. After that, the parameter group is available again.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UPE1026 - Parameter group &1 (&2) was designated for deletion ?

  The SAP error message UPE1026 indicates that a parameter group has been marked for deletion. This typically occurs in the context of configuration settings or parameter management within the SAP system. Here’s a breakdown of the cause, potential solutions, and related information:
  
  Cause:
  
  
  Parameter Group Marked for Deletion: The specific parameter group identified by the placeholders &1 (the name of the parameter group) and &2 (the description of the parameter group) has been flagged for deletion in the system. This could happen due to administrative actions or changes in configuration.
  
  
  Configuration Changes: Sometimes, during system upgrades or configuration changes, certain parameter groups may be deprecated or replaced, leading to them being marked for deletion.
  
  
  Data Consistency Issues: If there are inconsistencies in the configuration data or if the parameter group is referenced in other configurations, it may trigger this error.
  
  
  
  Solution:
  
  
  Check Parameter Group Status: Use transaction codes like SPRO (SAP Project Reference Object) or SE11