How To Fix UPC201 - InfoCube &1 does not exist

SAP Error Message - Details

• Message type: E = Error

• Message class: UPC - Planning: General Error Messages

• Message number: 201

• Message text: InfoCube &1 does not exist

What causes this issue?

You have attempted to carry out changes in a planning area. However,
the system could not find the InfoCube which is assigned to the
planning area.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the definition of the planning area. Possible causes could be:
The InfoCube it is based on was deleted. In this case you can no longer
use the planning area. You should delete the area and if necessary,
form a new InfoCube.
The InfoCube it is based on does not have the status 'active'
The InfoCube it is based on was renamed in SAP BW, after it was
assigned the planning area.
If the InfoCube is in another system: The RFC destination, through
which a connection was formed to the remote system, was changed,
renamed or deleted.
If the InfoCube is in another system: The connection to the remote
system can not be established due to hardware problems.
If you cannot ascertain the problem it is based on, then notify your
system administrator.

Error message extract from SAP system. Copyright SAP SE.